BohemianBabyDev wrote: ↑Tue Nov 09, 2021 6:16 pm
When it comes to replacing the top shaft and slipper with RC10 B4 parts what are all of the parts that need replacement?
I see some sets available but I didn't know which parts exactly that i need.
Is it just the slipper hub?
Maybe an Avid Stock slipper set?
Those are two separate routes.
Both require replacing the stock V1 stealth top shaft with a B4/T4 top shaft. If you get an aftermarket one be sure you don't get one with a molded in spacer.
Then there is the triad slipper route. I decided to use the triad slipper because it was few dollars cheaper, but it locks you into the schell/avid spur gears. I have only done this route. Basically you get everything you need,besides the top shaft, in the Triad kit, although you need a small spacer
There is Associated the stock slipper route that works like the re-release. I have heard of 2 ways of doing this.
you need the b4/t4 topshaft. the inner and outer slipper hubs, an associated spur gear , slipper pads and slipper spring.
There is lots of info here under WOIN(what's old is new)
One I hear a LOT less about so I don't even know if it works and it uses the V1 top shaft.
You use the V1 top shaft, the v1 Inner slipper, an newer associated spur with slipper pad set, a b4/t4 OUTTEr slipper hub and the original slipper spring.
This is supposed to let you use most of the old stealth, but with a slipper that can handle more power than the original stealth.