i was staring at it last night and thought, ya know what? this could make a cool rc10t chassis. the length is already there (actually a tad TOO long). so i cut, drilled, and countersunk the front kickup to 10t/worlds status. i also had to drill and countersink the holes for the steering bellcrank further to the rear, since the provided holes are for either the andy's slider bellcrank, or any designed to fit the rc10 buggy. and while i was at it, it drilled it for a stealth trans, too. eventually when i get them, i want to put the older gt cast nose brace tube mounts on it, and i also need to get a set of c.c. 10t bellcranks, since the stock ones don't work right using this chassis.
i kinda think this is gonna be 2009 V-nats truck class entry when it's all done.
Forgot about that part. It uses the same system as the GT. You could always get a long 8-32 screw and chuck it in a lathe to turn it down to fit the steering arms with a longer amount of threads remaining at the bottom, but that would probably be more work than just buying the CC setup.