Black & Blue RC10 OIN.2

[pumpkinfish]

How do we contact Jake?

[scr8p]

How do we contact Jake?

Seabass. He has them in the bst thread.

[askbob]

I have a new set of alloy B4 rear hubs I really want to use in this build. Need to jog my memory, but is there any rear arm/CVD combo that will allow the use of a B4 rear hub?
Also, did RPM ever make rear worlds arms in black?

[askbob]

Killer job by NCOHOG milling/cutting down the chassis and nose plate! RPM Worlds arms front & rear. A super fantastic paint job by Vintagemishal!
Just need a few hours to get the build going...

[yellabelly]

thats gonna be beautimus!!!

[askbob]

Turtle speed...

[scr8p]

turtle pace....... that's how i roll, too.

looks good so far. going with the long wheelbase setup on this i'm guessing?

[askbob]

Turtle always wins right?
Going to try the long wheelbase front and rear. The GT nose brace tubes should be the trick. Not sure on the alloy rear hubs I bought. They said GT hubs, but they look like 10T hubs to me. Hoping the B44 CVAs will work with them.

[Phin]

GT and 10T hubs are the same.

[scr8p]

GT and 10T hubs are the same.

x2. the rpm gt hubs are different. the axle is raised up in relationship to the hinge pin...... like the rpm worlds hub.

i've seen other guys use the ae hub with the worlds arms already so you may be ok.

[askbob]

Cool, thanks! I think they'll work. I have a set of the RPM GT hubs if not. Like you said, the axle is raised up quite a bit on the RPM version.

[askbob]

A little more progress.

[GoMachV]

Very nice!!

[janaya]

That is looking really nice. NCOHOG's mill work looks really good. I need to get some funds together to have him do some work on a chassis or 2.

[broodenburg]

stunning ....