Nice build, it's coming along great! Maybe consider the SRB / Rough Rider wheels and tires to help fill the wheel wheels out a bit. They are 1.75" versus 1.5".morrisey0 wrote: ↑Tue Mar 15, 2022 8:15 pm
The body sat just about like this with the motor installed, and then I realized that the battery hold down bracket screw holes lined up just about perfectly with the body jerry can screw holes. It was destiny the body should end up here. The rear body mounts will be here and covered up by the jerry cans. In this position, I like the back but think the front is a bit high visually. TBH though, front the susp arms hit the body at about half travel, so the whole front may need to come up another 3/16-1/4". I think it will be okay though. This pic is at full side view so it looks bad, but from a higher perspective, it still all looks great.
I also saw a post somewhere awhile ago about folks using a propane torch to "relieve" the plastic before priming it to get better adherence. I am digging around to see if I can find it.
-Mark