So what did you get in the post today ???

[1911Colt]

The obvious solution is to build another pink Top Cat.

[jcwrks]

I decided it was time to go vintage nitro with a nib kit.

[mikea96]

Some retro turnbuckles for 40th 10t.

[RC10th]

I decided it was time to go vintage nitro with a nib kit.

Awesome !!!

[Trass]

Today ,

Many spur gear and heat sink




Jerome

[R6cowboy]

Turnbuckles for my Stealth car and a Cyclone C2 because I don't have one and rarely pass up a really good deal on a Novak.

[R6cowboy]

More Stealth car business

[Dadio]

Been looking for years , God bless re re's.

[Dadio]

Been looking for years , God bless re re's.20241001_133319.jpg20241001_133351.jpg

Just to follow up it's not a direct fit , it needs trimming at the rear of the chain trough and the bracket to the servo saver is too deep so it lifts the front up away from the front bulkhead where it screws on , even the rear chain cover is slightly longer and the hole for the sprocket is slightly further forward . Both can be made to fit but neither is a drop in part

[Frankentruck]

I decided it was time to go vintage nitro with a nib kit.

It's already for sale? That's a nice paint job in the listing. Did Andy custom paint that on request?

[GoMachV]

It's already for sale?

I'm surprised it took that long!

[Dadio]

[jcwrks]

I decided it was time to go vintage nitro with a nib kit.
1000014928.png

It's already for sale? That's a nice paint job in the listing. Did Andy custom paint that on request?

No, that 7072 kit is unbuilt. I have a built 7058 listed. Andy painted it a while back. Not a bad looking scheme.

[Trass]

I'm on something necessary for my Serpent 988e Taipan runner that I will have Frantz (Manobet) do once the prototype is finished.... I already started V2

Can someone tell me what it is?



Jerome

[mikea96]

Front and rear wheels for my yz10 runner, rear wheels, bearings, trans brace and 8/32 titanium screws for C Stamp rc10 runner and battery box for my ten4.1